20452048909 November 9, 2018 07:19
591386935375 October 17, 2018 17:48
It is absolutely clear that you can draw transitions. However, in this case, Europe ONE basic 3 line combination is needed to be drawn.
Please use that to get passed.
20452048909 October 8, 2018 16:47
Unfortunately it can not be passed because of 2 reasons:
1. The lines in the transition (Europe ONE) can not touch each other.
2. The third line is too straight.
20452048909 September 30, 2018 11:13
Can not pass to the next level for the following reasons:
1. The first line of the transition can not start from the lower outer line, there has to be space in between.
2. Lines of the 3-level combination cannot touch each other.
3. The third line of the transition must start vertically underneath the first one.
587568316495 September 30, 2018 11:05
6607399053 September 18, 2018 19:10
Transition is accepted and you are elevated to the next level.
Please keep in mind that the first line of the transition should not reach the upper line.
6607399053 August 30, 2018 02:43
383740936232 August 3, 2018 04:36
One version of the brow is enough.
In this one the transition was beautiful and you are elevated to the next level.
In others there were minor flaws.
7075675725 July 13, 2018 03:55
20452048909 June 18, 2018 08:33
It is sloppy and there are mistakes - still, it was possible to elevate you!
- The first line of the transition should be longer.
- Lines of the transition can not touch each other
- The beginning lines are too short in 2 of your brows. In one brow, this is too long.
7075675725 June 18, 2018 06:02
Elevated to next level. Suggestion: you should consider making the first line of the transition longer (otherwise you may have to fill in this part later).
You can consider starting the first line of transition sooner so that the gaps in between the transition lines are smaller.
7075675725 May 16, 2018 03:15
Almost but not exactly what it has to be. Please check again the sample ant try to do the same.
You have to be able to make the lines smoothe and curved. Not too straight or too fat or double.
Make sure the where transition ends and from where you can begin with upper lines.
Please try again.
435552452648 April 30, 2018 09:33
You have uploaded many pictures and this is the closest one to what it should be. Not perfect but passed to the next level.
Please always compare you work with the sample according to the level you are.
20452048909 April 29, 2018 10:13
6465240333 April 20, 2018 09:32
Passed but not perfect.
Compare with sample - beginnings are ok but ends are spreading too much from each other.
20452048909 April 17, 2018 07:24
386360836136 April 13, 2018 07:13
OK - escalated to the level 5.
First one is OK. Second and third not. Keep the pattern lines inside the shape lines.
386360836136 April 7, 2018 07:21
Not passed. First transition line must go little bit higher. Lines can not touch each other. Make last line little bit longer.
Check the sample in Level 4 and try to follow it.
5172366349 February 20, 2018 03:10
223924944936 February 20, 2018 03:05
4864513613 February 14, 2018 11:42
5619340045 December 11, 2017 09:03
The middle line of the transition MUST NOT go past the point where the backbone starts! These are within error limits, except the picture at the upper right corner.
PLEASE END THE LINE AT THE RIGHT PLACE!!